Modular Handrail Designs




Modular Handrail Designs, LLC
2031 Carolina Place Drive
Fort Mill, SC  29708

Monday - Friday
8:00 A.M. TO 4:00 P.M. Eastern
Order Online 24/7

We ship to the U.S., Canada, and Puerto Rico.

All items are in stock unless otherwise noted.

Add items to shopping cart to see shipping options and pricing.


Stainless Steel and Glass Railings With Glass Clamps

Glass Rail With Clamps

See Components Diagram

1.9 top rail and posts1.9" ° Top Cap and Posts, 13 Gauge Wall
1.5 handrail1.5" °, Guardrail Post Mounted Handrail, 18 Gauge Wall
3/8 glass infill3/8" Clear Glass Infill and Perforated Stainless Infill (not
curved bracket saddleincluded)
square and round glass clampsSquare Glass Clamps and Round Glass Clamps
304 stainless railingStandard 304 Stainless Steel
mirror finish railingMirror Finish Only
top and side mounted railing
Side and Top Mounted
42 to 48 post spacingRecommended Post Spacing is 42" to 48"
Purchaser responsible for ensuring that desired parts and application meet load requirements.


PLEASE NOTE:  We do not sell our railing systems "by the section".  You must purchase all components required to build your railing section(s), based on the size and installation requirements of your particular project.  We do not sell standard-sized sections of our modular railings.  They do not come pre-assembled.


Finish:  All railing systems and components are polished to a #8, mirror finish.  Our products are solid stainless steel, and may be re-polished to your preferred finish.  However, we do not provide re-polishing services.

We do not stock any alternate finishes.

Post Spacing:  We recommend 42" to 48".

Tube Cutting:  We will provide posts cut to your custom size specifications for $5.00 per cut - for straight and/or mitered cuts, plus deburring. Just add your preferred, cut lengths in the "Ordering Instructions" box when checking out.

Tube Cutting Procedures:  Stainless steel tubing should be cut at a slow rotational speed.  At Modular Handrail Designs, we use Kasto cold saws with carbide-tipped saw blades at 24 RPM.  If you are using an abrasive saw, please be aware that it will generate a lot of heat between the tubing and cutting blade.  The heat produced by this process will discolor the stainless tubing, and will require polishing.  The polishing can be done using a polishing pad and rouge compound.  In general, chop saws and compound miter saws operate at a lower RPM than miter saws.  The lower the RPM, the better the resulting cut.

Infill Panels:  We do not offer glass or stainless steel infill panels.  It is incumbent upon the purchaser to arrange for their infill panels to be made at or before the time of purchasing the railing system.  Our railing systems accommodate 3/8" and 1/2" infill panels.

Drill & Tap:  We do not offer drilling and tapping services.  For information about drill bit sizes, please click here.

Need a sample?  Click here to order a sample piece of tubing, or a piece of solid 7/16" stainless rod.

How to order?  Click here for complete ordering information.


 SecurityMetrics for PCI Compliance, QSA, IDS, Penetration Testing, Forensics, and Vulnerability Assessment




Exclusive U.S. Reseller for Titoz«, a division of Rinox Engineering.
All Rights Reserved 2010-2012ę